Aqualogic Installation Hub

Add steps, tools list, notes or tables here.

• Adjustable wrench
• Phillips screwdriver
• Measuring tape

1. Mount faucet to sink or countertop (use escutcheon if needed).
2. Connect pullout spray hose and fit counterweight.
3. Install filtration bracket (if included) on cabinet side.
4. Cold supply → angle shut-off → (optional) leak detector → filter IN → filter OUT → tank IN (green).
5. Tank outlets: blue = filtered; red = instant hot. Fit silicone tubes, secure with pinch clamps.
6. Connect faucet hot/cold to mains; connect filtered & instant hot to tank per diagram.
7. Turn water on, check for leaks; plug tank into grounded outlet.
8. Prime: touch & hold sensor to fill; flush cold/hot ~1 min; filtered auto-stops ~2 L; flush instant hot ≥1 min.

Repair or replacement warranty (no labor). Requires product registration within 30 days and proof of filter replacement every 6 months.

• Mount faucet securely; tighten mounting nut & set screws (do not over-tighten).
• Connect hot and cold supplies (hand-tight + ¼ turn).
• Flush lines and check for leaks; ensure pull-down hose weight moves freely.

1. Shut off water; open faucet to depressurize.
2. Twist old cartridge off; dispose appropriately.
3. Twist new cartridge on; ensure arrow/flow direction is correct.
4. Turn water on; flush for 2–3 minutes to clear fines.

Reminder: replace filters every 6 months (keep proof for warranty).

1. Insert faucet through 1-3/8" hole; fit rubber/metal washers; tighten mounting nut & set screws.
2. Connect to filter/RO outlet line.
3. Turn on water and flush 2–3 minutes; check for leaks.

1. Disconnect power; remove old disposer/strainer.
2. Apply plumber’s putty; install sink flange & mounting assembly.
3. Hang disposer on mounting ring; twist to lock.
4. Connect discharge to trap; remove dishwasher knockout and attach hose if needed.
5. Wire per code or connect power cord; test for leaks and operation.

1. Wear gloves and safety glasses.
2. Switch off power and close inlet valve to the tank.
3. Use the Aqualogic Descale Pack: add solution via pipette per instructions; soak ~20 minutes.
4. Open inlet and flush thoroughly until taste/odor is clear.

1 bottle = 2 treatments (1 year). Extra solution bottles sold separately.

• Run a steady stream of cold water before switching on; feed waste gradually.
• Run water 10–15 seconds after switching off to clear lines.
• Do not dispose of grease/fats, fibrous husks, large bones, or non-food items.
• Use reset if tripped; power off before clearing jams (use hex key on base if applicable).